20 watt full tube guitar top with two channels and power soak
With the Engl E606 Ironball Head, the amplifier manufacturer from Tittmoning, Bavaria, presents a compact guitar amplifier in full tube design, which is equally suitable for use on stage and in recording studios. Accordingly, the top has two channels with common 3-band tone control and switchable gain boost, which cover the entire spectrum between crystal-clear clean and brute heavy metal. The integrated reverb effect adds a three-dimensional dimension to the sound, while additional effect devices can be looped in via the serial effect path. The power amplifier of the Engl Ironball draws a maximum of 20 watts from two EL84 tubes, which can be reduced to 5 watts or one watt with the integrated Power Soak. In addition, a load resistor can be switched on, which enables silent recording operation without connected loudspeakers. For this purpose, a balanced line out with speaker simulation is also available, which can be found on the headphone jack.
The Engl E606 Ironball Head at a glance:
Solid tube top with integrated power soak, made in Germany
Preamplifier with four ECC83, output stage with two EL84
20 Watt power, reducible to 5 Watt and 1 Watt
Clean and lead channel with separate gain controls
Common 3-band tone control for each channel
Switchable Gain Boost
Integrated reverb effect with controller on the rear panel
Balanced line out with speaker simulation (6.35 mm stereo jack)
Headphone connection with speaker simulation
Speaker terminals for 8 Ohm and 16 Ohm
Connection for optionally available foot switch Engl Z-3 or Engl Z-4
